CLI Guide

To remove the MSDP peer, use the no ip msdp peer peer address
[connect-source interface] [description name] [sa-limit number]
command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-source
interface
Enter the keywords connect-source then one of the
interfaces and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
description name (OPTIONAL) Enter the keyword description then a
description name (maximum 80 characters) to designate a
description for the MSDP peer.
sa-limit number (OPTIONAL) Enter the maximum number of SA entries in
SA-cache. The range is from 1 to 100000. .
Defaults See Parameters .
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
1114
Multicast Source Discovery Protocol (MSDP)