CLI Guide

ip msdp cache-rejected-sa

Enable an MSDP cache for the rejected source-active entries.

Syntax

ip msdp cache-rejected-sa {number}

To clear the MSDP rejected source-active entries, use the no ip msdp cache-

rejected-sa {number} command then the ip msdp cache-rejected-sa

{

number} command.

Parameters

number Enter the number of rejected SA entries to cache. The range

is from 0 to 32766.

Defaults None

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.4.1.0 Introduced

Commands

• show ip msdp sa-cache rejected-sa — display the rejected SAs in the SA cache.

Multicast Source Discovery Protocol (MSDP)

1109