CLI Guide

Version Description
7.6.1.0 Introduced on the C-Series.
Usage Information Advertise the Extended Power via MDI on all ports that are connected to an 802.3af
powered, LLDP-MED endpoint device.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
Example
Dell(conf)#int gigabitethernet 1/1
Dell(conf-if-gi-1/1)#protocol lldp
Dell(conf-if-gi-1/1-lldp)#advertise med power-via-mdi
Dell(conf-if-gi-1/1-lldp)#show config
!
protocol lldp
advertise med power-via-mdi
Dell(conf-if-gi-1/1-lldp)#
advertise med softphone-voice
To advertise softphone to enable IP telephony on a computer so that the computer can be used as a
phone, configure the system.
Syntax
advertise med softphone-voice {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med softphone-voice
{vlan-id layer2_priority DSCP_value} | {priority-tagged number}
command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged, the Layer 2 priority,
and then the DSCP value.
Defaults Unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
Link Layer Discovery Protocol (LLDP)
1095