CLI Guide
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Syntax
show lldp neighbors [interface interface] [detail]
Parameters
interface interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the
TLV information, remote management IP addresses, timers,
and LLDP tx and rx counters.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Modified output of detail parameter to display remote
management IP addresses.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
Link Layer Discovery Protocol (LLDP)
1087