CLI Guide

Version Description
Legacy E-Series
command.
Related
Commands
fefd — enable far-end failure detection.
fefd reset
Reset all interfaces or a single interface that was in “error-disabled” mode.
Syntax
fefd reset [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Related
Commands
fefd — enable far-end failure detection.
1068
Layer 2