CLI Guide

level-2 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level 2 routes. This setting is the default.
match {external |
internal}
(OPTIONAL) The command used for OSPF to route and
redistribute into other routing domains. The values are
• internal
• external
route-map map-
name
map-name is an identifier for a configured route map. The
route map should filter imported routes from the source
routing protocol to the current routing protocol.
If you do not specify a map-name, all routes are
redistributed. If you specify a keyword, but fail to list route
map tags, no routes are imported.
Defaults See Parameters.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage Information How a metric value assigned to a redistributed route is advertised depends on how
on the configuration of the metric-style command. If the metric-style
command is set for Narrow mode and the metric value in the redistribute
ospf
command is set to a number higher than 63, the metric value advertised in
LSPs is 63. If the metric-style command is set for wide mode, the metric value
in the
redistribute ospf command is advertised.
1008
Intermediate System to Intermediate System (IS-IS)