CLI Guide

multi-topology
Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prefix
information in the LSPs.
Syntax
multi-topology [transition]
To return to a single topology configuration, use the no multi-topology
[transition] command.
Parameters
transition
Defaults Disabled
Command Modes CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.8.1.0 Introduced.
net
To configure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If
you did not configure a NET, the IS-IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-
title
Specify the area address and system ID for an IS-IS routing
process. The first 1 to 13 bytes identify the area address. The
next 6 bytes identify the system ID. The last 1 byte is the
Intermediate System to Intermediate System (IS-IS)
1001