Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

921

922

923

924

925

926

927

928

929

930

Version Description

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.4.1.0 Introduced

Commands

• show ip msdp sa-cache rejected-sa — display the rejected SAs in the SA cache.

ip msdp default-peer

Define a default peer from which to accept all source-active (SA) messages.

Syntax

ip msdp default-peer peer address [list name]

To remove the default peer, use the no ip msdp default-peer {peer address} list name

command.

Parameters

peer address

Enter the peer address in a dotted decimal format (A.B.C.D.)

list

name

Enter the keywords list name and specify a standard access list that contains the RP

address that should be treated as the default peer. If no access list is specified, then all

SAs from the peer are accepted.

Defaults Not configured.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.