Administrator Guide

Command History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
Usage Information You can partition the LPM table to store IPv6 prefixes greater than /64 mask length. Requires reboot of the
switch to take effect as the SDK handles this only during its initialization.
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a stack unit.
Syntax
clear ipv6 fib [vrf vrf-name]| stack-unit unit-number
Parameters
vrf vrf–name (Optional) Enter the keyword vrf followed by the name of the VRF to clear the neighbor
corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are cleared.
slot Enter the slot number to clear the FIB.
unit-number Enter the stack member number. The range is from 1to 6
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
756 IPv6 Basics