Administrator Guide

debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast soft-
reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-group-
name] ipv6 unicast soft-reconfiguration command.
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor on which you want to enable soft-reconfiguration
debugging.
peer-group-name Enter the name of the peer group on which you want to enable soft-reconfiguration
debugging.
ipv6 unicast Debug soft reconfiguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series.
Usage Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If no neighbor is
specified, debug is turned on for all neighbors.
ipv6 prefix-list
Configure an IPv6 prefix list.
Syntax
ipv6 prefix-list prefix-list name
Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list names.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant DellEMC
Networking OS Command Line Reference Guide.
Border Gateway Protocol 441