Administrator Guide

IPADDR:NN Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4
Unicast Address:2-byte community value).
additive (OPTIONAL) Enter the keyword additive to add to the existing extended community.
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP extended
community.
Defaults none
Command Modes ROUTE MAP (config-route-map)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T
8.3.11.1 Introduced on the Z-9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Usage Information
If the set community rt and soo are in the same route-map entry, the behavior defines as:
• If the rt option comes before soo, with or without the additive option, soo overrides the communities rt
sets.
• If the rt option comes after soo, without the additive option, rt overrides the communities soo sets.
• If the rt with the additive option comes after soo, rt adds the communities soo sets.
Related
Commands
• set extcommunity soo — set the extended community site-of-origin in the route-map.
set extcommunity soo
To set extended community site-of-origin in Route Map, use this feature.
Syntax
set extcommunity soo {as4 ASN4:NN | ASN:NNNN | IPADDR:NN [non-trans]}
To delete the site-of-origin community, use the no set extcommunity command.
Parameters
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific extended community number in the
format ASN4:NN (4-byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2-
byte AS number:4-byte community value).
IPADDR:NN Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4
Unicast Address:2-byte community value).
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP extended
community.
Border Gateway Protocol 437