Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up
to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information Use caution when you delete route maps because if you do not specify a sequence number, all route maps with
the same map-name are deleted when you use the no route-map map-name command.
Example
DellEMC(conf)# route-map dempsey
DellEMC(config-route-map)#
Related
Commands
• show config — display the current configuration.
set as-path
To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
Syntax
set as-path prepend as-number [... as-number]
To remove an AS-Path setting, use the no set as-path {prepend as-number | tag} command.
Parameters
prepend as-
number
Enter the keyword prepend and then enter up to eight AS numbers to be inserted into
the BGP path information. The range is from 1 to 65535.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Access Control Lists (ACL) 245