Administrator Guide

show ip
accounting
access-
lists Field
Description
“Extended IP...” Displays the name of the IP ACL.
“seq 5...” Displays the filter. If the keywords count or byte were configured in the filter, the
number of packets or bytes the filter processes is displayed at the end of the line.
“order 4” Displays the QoS order of priority for the ACL entry.
Example
DellEMC# show ip accounting access-list L3-ACL vrf vrf3
!
Standard Ingress IP access list L3-ACL on vrf3
Total cam count 3
seq 5 permit 10.1.2.0/24 any negotiate 150 monitor 300 count (0 packets)
seq 10 permit 20.1.2.0/24
seq 15 permit 30.1.2.0/24
DellEMC#
show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and the count of matches/mismatches
against each ACL entry displayed.
Syntax
show ip access-lists [access-list-name] [interface interface] [in | out] [vrf
vrf-name]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface followed by the one of the following keywords and slot/
port or number information:
• For a VLAN interface, enter the keyword vlan followed by the slot/port number.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed
by the slot/port information.
•
For a Port Channel interface, enter the keyword port-channel followed by a
number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
in | out Identify whether ACL is applied on the ingress or egress side.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to display the access-lists that are
configured on either the default or non-default VRFs.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.5.1.0 Added support for the 4-port 40G line cards on the E-Series.
Access Control Lists (ACL) 185