Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1641

the received certificate’s sha-1 fingerprint against this configured sha-1 fingerprint. If

present, only the fingerprint is used for certificate revocation validation.

port

port-number

Enter the keyword port followed by the port number. The default port number is 6514

for secure logging.

Defaults None.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command:

Version Description

9.11.0.0 Introduced this command.

Usage Information The following RBAC roles are allowed to issue this command:

• sysadmin

• secadmin

Following are the pre-requisites to configure logging:

• The logging command must be configured to enable event logging.

• A certificate must be installed on the switch. This certificate is only used for secure logging.

• At least one CA certificate must be installed on the switch so that the logging server’s certificate can be

verified. If a SHA1 fingerprint is present, only the fingerprint is used for certificate revocation validation.

Commands

• crypto cert install

• crypto ca-cert install

• crypto cert generate

crypto x509 ca-keyid

Creates a per-certificate configuration context using the specified subject key identifier.

Syntax

crypto x509 ca-keyid subject-key-identifier

Use to the no crypto x509 ca-keyid command to remove this configuration.

Parameters

subject-key-

identifier

Enter the content of the SubjectKeyIdentifier field from the CA certificate.

NOTE: To get the subject key identifier details, enter the show crypto ca-

cert command. This command displays the CA certificate details.

Defaults None.

Command Modes

• CONFIGURATION Mode