Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1581

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.

Usage Information It is possible to configure multiple import conditions per VRF depending on the exporting VRF.

The export-target and import-target support only the match protocol and match prefix-list options. Other options

that are configured in the route-maps are ignored.

Commands

• ip route-export – exports routes to another VRF.

ipv6 route-export

Enables route leaking between VRFs. This command exports or shares IPv6 routes corresponding to one VRF with other nondefault VRFs.

Syntax

ipv6 route-export tag [route-map-name]

Parameters

route-export Enter the keywords route-export to leak or share routes between VRFs.

tag

Enter a tag (ASN number) as the export route target to expose routes to other VRFs.

This tag acts as an identifier for exported routes. Use this identifier while importing these

routes into another nondefault VRF.

route-map-name

(Optional) Enter the name of the route-map to filter the exported routes. You can leak

global routes to be made available to VRFs. As the global RTM usually contains a large

pool of routes, when the destination VRF imports global routes, these routes are

duplicated into the VRF's RTM. It is mandatory to use route-maps to filter out leaked

routes while sharing global routes with VRFs.

Defaults N/A

Command Modes

• VRF mode

• CONFIGURATION mode

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.