Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1501

with the highest priority value is chosen to become the management unit if the active

management unit fails or on the next reload.

Defaults 1

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

Commands

• reload – reboots Dell EMC Networking OS.

stack-unit provision

Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the management unit.

Syntax

stack-unit [stack-number] provision {model-identifier}

Parameters

stack-number

Enter a stack member identifier of the switch that you want to add to the stack.

model-identifier

Enter the model identifier of the switch to be added as a stack member. This identifier is

also referred to as the provision type.

Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member identifier.