Administrator Guide

Mgmt ID: 1
Stack-unit ID: 12
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: 1-0(0-4697)
Link to Peer: Up
-- PEER Stack-unit Status --
------------------------------------------------
Stack-unit State: Standby
Peer Stack-unit ID: 2
Stack-unit SW Version: 1-0(0-4697)
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 1
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
stack-unit Config: succeeded Feb 25 2016 00:11:35
SSMGR: succeeded Feb 25 2016 00:11:35
Start-up Config: succeeded Feb 25 2016 00:11:35
Runtime Event Log: succeeded Feb 25 2016 00:11:35
Running Config: succeeded Feb 25 2016 00:11:38
ACL Mgr: succeeded Feb 25 2016 00:11:35
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
CRYPTOMGR: succeeded Feb 25 2016 00:11:35
DellEMC#
show system stack-ports
Display information about the stacking ports on all switches in the stack.
Syntax
show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the command output without the
Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface and
Connection fields.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the stacking range to 12 units in S3100 series.
Stacking 1501