Administrator Guide

offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in | out} offset
[interface] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine which incoming routes are
modified.
offset Enter a number from zero (0) to 16 to be applied to the incoming route metric matching
the access list specified. If you set an offset value to zero (0), no action is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information When the offset metric is applied to an interface, that value takes precedence over an offset value that is not
extended to an interface.
Related
Commands
• ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.
1260 Routing Information Protocol (RIP)