Administrator Guide
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
pre- 7.7.1.0 Introduced.
Related
Commands
• policy-map-input — creates an input policy map.
• policy-map-output — creates an output policy map.
• qos-policy-input — creates an input QoS-policy on the router.
• qos-policy-output — creates an output QoS-policy on the router.
• wred-profile — creates a WRED profile.
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
NOTE:
IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any class-maps on
both ACLs as well as VLANs.
Syntax
[seq sequence number] match ip access-group access-group-name [set-ip-dscp
value | set-color value]
To remove ACL match criteria from a class map, use the no [seq sequence number] match ip
access-group access-group-name [set-ip-dscp value | set-color value] command.
Parameters
seq
sequence
number
(OPTIONAL) Enter the keyword seq then the sequence number. The range is from 1 to
100. By default, the sequence number are assigned in multiples of five.
access-group-
name
Enter the ACL name whose contents are used as the match criteria in determining if
packets belong to the class the class-map specifies.
set-ip-dscp
value
(OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The matched
traffic is marked with the DSCP value. The range is from 0 to 63.
set-color
value
(Optional) Enter the keyword set-color followed by a color value. Traffic that fulfills the
match criteria is marked with the color value that you specify. The default value is Yellow.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the seq option for the class-map on all the Dell EMC Networking OS
platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
Quality of Service (QoS) 1207