Administrator Guide
dscp_value
DSCP value of the packets in the ERSPAN traffic. The range is from 0 to 63. The default
value is 0.
set ip ttl Configures the IP time-to-live (TTL) value of the Encapsulated Remote Switched Port
Analyzer (ERSPAN) traffic. To revert to the default configuration, use the no form of this
command.
ttl_value
IP TTL value of the ERSPAN traffic. The range is from 1 to 255. The default value is 255.
drop Monitors only the dropped packets in the Ingress.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the drop parameter.
9.7(0.0) Introduced on the S6000-ON. Introduced the set ip dscp and set ip ttl
parameters.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information The monitor command is saved in the running configuration at Monitor Session mode level and can be restored
after a chassis reload.
Example
DellEMC# show monitor session
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL
------ ------ ----------- --- ---- --------- -------- ---- ---
0 Gi 1/12 remote-ip rx Flow 1.1.1.1 7.1.1.2 0 255
0 Po 1 remote-ip tx Flow 1.1.1.1 7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow 5.1.1.1 3.1.1.2 0 255
Related Command
• show monitor session — displays the monitor session.
• show running-config monitor session — displays the running configuration of a monitor session.
rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Port Monitoring 1171