Administrator Guide

Reply to request 5 from 172.31.1.87 0 ms
DellEMC#
Example (IPv6)
DellEMC# ping 100::1
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds:
!!!!!
Success rate is 100.0 percent (5/5), round-trip min/avg/max = 0/0/0 (ms)
DellEMC#
reload
Reboot the system.
Syntax
reload [conditional nvram-cfg-change | no-confirm [discard-running]]
Parameters
conditional nvram-
cfg-change
(OPTIONAL) Reload into the Dell EMC Networking Operating System (OS) if the
condition is true. A configuration change to the NVRAM requires a switch reload. To
reload the switch, select nvram-cfg-change.
no-confirm
[discard-running]
Reload the chassis without prompting for further confirmation.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0)
Introduced the no-confirm option.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell EMC Networking OS.
116 Control and Monitoring