Administrator Guide

To remove the rule, use one of the following:
• If you know the filter sequence number, use the no seq sequence-number syntax command.
• You can also use the no permit {ip-protocol-number | protocol-type} {source mask |
any | host ip-address} {destination mask | any | host ip-address} [bit]
[operators] command.
Parameters
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
host ip-address Enter the keyword host then he IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the portcommand
parameter.)
Defaults None
Command Modes REDIRECT-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Policy-based Routing (PBR) 1113