Administrator Guide

For address family: IPv4 Unicast
BGP neighbor is test
Number of peers in this group 1
Peer-group members (* - outbound optimized):
100.100.100.100*
DellEMC#
router bgp 65517
neighbor test peer-group
neighbor test
fall-over
neighbor test no shutdown
neighbor 100.100.100.100 remote-as 65517
neighbor 100.100.100.100
fall-over
neighbor 100.100.100.100 update-source Loopback 0
neighbor 100.100.100.100 no shutdown
DellEMC#
Conguring Passive Peering
When you enable a peer-group, the software sends an OPEN message to initiate a TCP connection.
If you enable passive peering for the peer group, the software does not send an OPEN message, but it responds to an OPEN message.
When a BGP neighbor connection with authentication congured is rejected by a passive peer-group, Dell EMC Networking OS does not
allow another passive peer-group on the same subnet to connect with the BGP neighbor. To work around this, change the BGP
conguration or change the order of the peer group conguration.
You can constrain the number of passive sessions accepted by the neighbor. The limit keyword allows you to set the total number of
sessions the neighbor will accept, between 2 and 265. The default is 256 sessions.
1 Congure a peer group that does not initiate TCP connections with other peers.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | ipv6–address | peer-group-name} peer-group passive limit
Enter the limit keyword to restrict the number of sessions accepted.
2 Assign a subnet to the peer group.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | ipv6–address | peer-group-name} subnet subnet-number mask
The peer group responds to OPEN messages sent on this subnet.
3 Enable the peer group.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | ipv6–address | peer-group-name} no shutdown
4 Create and specify a remote peer for BGP neighbor.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | ipv6–address | peer-group-name} remote-as as-number
Only after the peer group responds to an OPEN message sent on the subnet does its BGP state change to ESTABLISHED. After the peer
group is ESTABLISHED, the peer group is the same as any other peer group.
For more information about peer groups, refer to Congure Peer Groups.
Border Gateway Protocol (BGP)
217