Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.4.2.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage
Information
Before you enable IPsec encryption on an OSPFv3 interface, first enable OSPFv3 globally on the router.
Configure the same encryption policy (same SPI and keys) on each interface in an OSPFv3 link.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the router.
When you configure encryption for an OSPFv3 area with the area encryption command, you enable
both IPsec encryption and authentication. However, when you enable authentication on an area with the
area authentication command, you do not enable encryption at the same time.
If you have enabled IPsec authentication in an OSPFv3 area with the area authentication
command, you cannot use the area encryption command in the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over an area-level
configuration. If you remove an interface configuration, an area encryption policy that has been
configured is applied to the interface.
To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi number
command.
Related
Commands
● ipv6 ospf encryption – configure an IPsec encryption policy on an OSPFv3 interface.
● show crypto ipsec policy – display the configuration of IPsec encryption policies.
clear ipv6 ospf process
Reset an OSPFv3 router process without removing or re-configuring the process.
Syntax
clear ipv6 ospf [vrf vrf-name] process
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to clear IPv6
routes corresponding to that VRF.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for C-Series.
998 Open Shortest Path First (OSPFv2 and OSPFv3)