Users Guide

Version Description
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
E-Series Original command.
Related
Commands
● exit — returns to the lower command mode.
exec-timeout
Set a time interval that the system waits for input on a line before disconnecting the session.
Syntax
exec-timeout minutes [seconds]
To return to default settings, use the no exec-timeout command.
Parameters
minutes Enter the number of minutes of inactivity on the system before disconnecting the
current session. The range is from 0 to 35791. The default is 10 minutes for the
console line and 30 minutes for the VTY line.
seconds (OPTIONAL) Enter the number of seconds. The range is from 0 to 2147483. The
default is 0 seconds.
Defaults 10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes LINE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
To remove the time interval, enter exec-timeout 0 0.
90 Control and Monitoring