Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

Table Of Contents

Command Modes EXEC

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.0) Added support for roles on the Z9000, S6000, S4820T, S4810, and MXL.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

8.1.1.0 Introduced on the E-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

E-Series Original command.

Usage

Information

Users entering EXEC Privilege mode or any other configured privilege level can access configuration

commands. To protect against unauthorized access, use the enable password command to configure

a password for the enable command at a specific privilege level. If no privilege level is specified, the

default is privilege level 15.

NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an

enable password.

Commands

● enable password — configures a password for the enable command and to access a privilege level.

enable optic-info-update interval

Enable polling intervals of optical information updates for simple network management protocol (SNMP).

Syntax

enable optical-info-update [interval seconds]

To disable optical power information updates, use the no enable optical-info-update

interval command.

Parameters

interval

seconds

Enter the keyword interval then the polling interval in seconds. The range is

from 120 to 6000 seconds. The default is 300 seconds (5 minutes).

Defaults Disabled

Command Modes CONFIGURATION