Users Guide

Related
Commands
● show ip msdp sa-cache rejected-sa — display the rejected SAs in the SA cache.
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address} list name
command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard access list that contains
the RP address that should be treated as the default peer. If no access list is
specified, then all SAs from the peer are accepted.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added the list option and removed the prefix-list option.
7.4.1.0 Introduced
Usage
Information
If a list is not specified, all SA messages received from the default peer are accepted. You can enter
multiple default peer commands.
ip msdp log-adjacency-changes
Enable logging of MSDP adjacency changes.
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
866 Multicast Source Discovery Protocol (MSDP)