Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
The advertise dot3–tlv power—via—mdi command enables the system to advertise IEEE 802.3
at power-via-mdi TLV to advertise its power negotiation capabilities with the powered devices via Link
Layer Discovery Protocol (LLDP). You can configure this command either on a specific interface or
globally.
Example
Dell(conf)# int gigabitethernet 1/1
Dell(conf-if-gi-1/1)#protocol lldp
Dell(conf-if-gi-1/1-lldp)#advertise dot3-tlv power-via-mdi
Dell(conf-if-gi-1/1-lldp)#show config
!
protocol lldp
advertise dot3-tlv power-via-mdi
Dell(conf-if-gi-1/1-lldp)#
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
Syntax
advertise management-tlv {management-address | system-capabilities |
system-description | system-name}
To remove advertised management TLVs, use the no advertise management-tlv
{management-address | system-capabilities | system-description | system-
name} command.
Parameters
management-
address
Enter the keyword management-address to advertise the management IP address
TLVs to the LLDP peer.
system-
capabilities
Enter the keywords system-capabilities to advertise the system capabilities
TLVs to the LLDP peer.
system-
description
Enter the keywords system-description to advertise the system description
TLVs to the LLDP peer.
system-name Enter the keywords system-name to advertise the system name TLVs to the
LLDP peer.
Defaults None
Command Modes CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
Link Layer Discovery Protocol (LLDP) 839