Users Guide

Usage
Information
Dell Networking recommends configuring metrics on all interfaces. Without configuring this command, the
IS-IS metrics are similar to hop-count metrics.
isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
isis password
Configure an authentication password for an interface.
Syntax
isis password [hmac-md5] password [level-1 | level-2]
To delete a password, use the no isis password [password] [level-1 | level-2]
command.
Parameters
encryption-type (OPTIONAL) Enter 7 to encrypt the password using DES.
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the password using MD5.
password Assign the interface authentication password.
level-1 (OPTIONAL) Independently configures the authentication password for Level 1.
The router acts as a station router for Level 1 routing. This setting is the default.
level-2 (OPTIONAL) Independently configures the authentication password for Level 2.
The router acts as an area router for Level 2 routing.
Defaults No default password. level-1 (if not otherwise specified).
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Intermediate System to Intermediate System (IS-IS) 771