Users Guide

Parameters
pps Enter the maximum number of error packets generated per second. The range is
from 1 to 200, where 0 disables the rate-limiting.
Default 100 pps
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the protocol operations to fill the field, use the no
ipv6 flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
If the flowlabel value is already set for BGP or SSH, the system defaults to the already configured
value. All packets on the same connection are considered part of the same flow by the system. For new
connections, set the new flowlabel to zero.
718 IPv6 Basics