Users Guide

cam-acl-egress
Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
● L2 ACL(l2acl): 1
● L3 ACL (ipv4acl: 1
● IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl
1- 4 ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the
CAM profile name then the amount to be allotted. The total space allocated must
equal 4. The ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.2.0 Introduced on the E-Series.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start), then reload the system.
The total amount of space allowed is 4 FP Blocks.
Example
Dell# configure
Dell(conf)# cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
Dell(conf)# cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
Dell(conf)# cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
Dell(conf)#
710 IPv6 Access Control Lists (IPv6 ACLs)