Users Guide

Command Modes CONFIGURATION INTERFACE (conf-if-range)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell(conf)# interface range gigabitethernet 1/1 - 1/2
Dell(conf-if-range-gi-1/1-2)# show config
!
interface GigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface GigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-1/2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface-type[—range]
Parameters
interface Enter one of the following keywords and the interface information:
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For stack-units, enter the keywords stack-unit then the slot/port
information.
● For a Null interface, enter the keyword null then the Null interface number.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
Interfaces 591