Users Guide

Input Statistics:
...
User Information
Both sides of the link must have auto-negotiation enabled or disabled for the link to come up.
The following details the possible speed and auto-negotiation combinations for a line between two
10/100/1000 Base-T Ethernet interfaces.
Port 0
● auto-negotiation enabled* speed 1000 or auto
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation enabled* speed 1000 or auto
Port 1
● auto-negotiation enabled* speed 1000 or auto
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
● Up at 1000 Mb/s
● Up at 100 Mb/s
● Up at 100 Mb/s
● Down
● Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
monitor interface
Monitor counters on a single interface or all interfaces. The screen is refreshed every five seconds and the CLI prompt
disappears.
Syntax
monitor interface [interface]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
● For the Management interface on the stack-unit, enter the keyword
managementEthernet then the slot/port information.
● For a port channel interface, enter the keyword port-channel and then a
number.
● For a Tunnel interface, enter the keyword tunnel then the slot/port. The
range is from 1 to 16383.
● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
584 Interfaces