Users Guide

● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a Tunnel interface, enter the keyword Tunnel then a number from 1 to
16383.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P2) Introduced on the S4038-ON.
9.8(0.0P5) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.2.1.0 Added support for 4093 VLANs on E-Series. Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When creating an interface range, interfaces appear in the order they are entered; they are not sorted.
The command verifies that interfaces are present (physical) or configured (logical).
Important Points to Remember:
● Bulk configuration is created if at least one interface is valid.
● Non-existing interfaces are excluded from the bulk configuration with a warning message.
● The interface range prompt includes interface types with slot/port information for valid
interfaces. The prompt allows for a maximum of 32 characters. If the bulk configuration exceeds
32 characters, it is represented by an ellipsis ( ... ).
● When the interface range prompt has multiple port ranges, the smaller port range is excluded
from the prompt.
● If overlapping port ranges are specified, the port range is extended to the smallest start port and the
biggest end port.
Example (Bulk)
Dell(conf)# interface range gigbitethernet 1/1 - 1/11,
tengigabitethernet 3/3, gigbitethernet 3/10
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
(Multiple Ports)
Dell(conf)# interface range gigabitethernet 2/10 - 2/23, gigabitethernet
2/12 - 2/17
Dell(conf-if-range-gi-2/10-2/23)#
Interfaces 577