Users Guide

Parameters
copper Enter the keyword copper to provision the combo port as a copper port.
fiber Enter the keyword fiber to provision the combo port as a fiber port.
Defaults None
Command Modes INTERFACE
Command
History
Version Description
9.10(0.0) Introduced on the S3100 series.
Usage
Information
By default, a combo port is in Hybrid mode. Use the combo-port-type command to provision the
combo port as either copper or fiber. Use the no combo-port-type command to change the combo
port to Hybrid mode.
Example
Dell(conf-if-gi-1/23)# combo-port-type copper
Dell(conf-if-gi-1/23)# combo-port-type fiber
dampening
Configure dampening on an interface.
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-
suppress-time]]
Parameters
half-life Enter the number of seconds after which the penalty is decreased. The penalty
decreases half after the half-life period expires. The range is from 1 to 30 seconds.
The default is 5 seconds.
reuse-threshold Enter a number as the reuse threshold, the penalty value below which the interface
state is changed to “up”. The range is from 1 to 20000. The default is 750.
suppress-
threshold
Enter a number as the suppress threshold, the penalty value above which the
interface state is changed to “error disabled”. The range is from 1 to 20000. The
default is 2500.
max-suppress-
time
Enter the maximum number for which a route can be suppressed. The default is
four times the half-life value. The range is from 1 to 86400. The default is 20
seconds.
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Interfaces 565