Users Guide

ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface
interface
Enter the following keywords and the interface information:
● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command.
Usage
Information
The Dell Networking OS provides the capability of statically configuring the interface to which a multicast
router is attached. To configure a static connection to the multicast router, enter the ip igmp
snooping mrouter interface command in the VLAN context. The interface to the router must
be a part of the VLAN where you are entering the command.
558 Internet Group Management Protocol (IGMP)