Users Guide

File Management
This section contains command line interface (CLI) commands needed to manage the configuration files, as well as other file
management commands.
Topics:
• boot system
• cd
• copy
• delete
• dir
• format
• fsck flash
• mkdir
• mount nfs
• rmdir
• upgrade system
• rename
• restore factory-defaults
• show boot system
• show bootvar
• show file-systems
• show os-version
• show running-config
• show startup-config
• show version
• upgrade
boot system
Specify the location where the Dell Networking OS image used to boot the system is stored.
Syntax
boot system {gateway ip-address | stack-unit {stack-unit-number | all}
{default | primary | secondary} {ftp: | nfsmount: | system: {A: | B: | bmp-
boot} | tftp: | usbflash:}}
To return to the default boot sequence, use the no boot system command.
Parameters
gateway Enter the IP address of the default next-hop gateway for the management subnet.
ip-address Enter an IP address in dotted decimal format.
stack-unit Enter the stack-unit number for the master switch.
all Enter the keyword all for all the stack units.
stack-unit-
number
Enter the stack-unit number. The range is from 1 to 12.
default Enter the keyword default to specify the default Dell Networking OS image.
primary Enter the keyword primary to specify the primary Dell Networking OS image.
secondary Enter the keyword secondary to specify the secondary Dell Networking OS
image.
3
52 File Management