Users Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000-ON, and Z-Series.
ip dhcp snooping database
Delay writing the binding table for a specified time.
Syntax
ip dhcp snooping database write-delay minutes
Parameters
minutes The range is from 5 to 21600.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
ipv6 dhcp snooping database write-delay
To set time interval for storing the snooping binding entries in a file.
Syntax
[no] ipv6 dhcp snooping database write-delay value
To disable the storing of snooping binding entries in a file, use the no ipv6 dhcp snooping write-
delay command.
Dynamic Host Configuration Protocol (DHCP) 483