Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
8.2.1.0 Introduced on the C-Series and S-Series.
Related
Commands
● arp inspection-trust — specify a port as trusted so that ARP frames are not validated against the
binding table.
arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
Syntax
arp inspection-trust
Defaults Disabled
Command Modes
● INTERFACE
● INTERFACE PORT-CHANNEL
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
8.2.1.0 Introduced on the C-Series and S-Series.
Related
Commands
● arp inspection — enable dynamic ARP inspection on a VLAN.
clear ip dhcp snooping
Clear the DHCP binding table.
Syntax
clear ip dhcp snooping {binding | source-address-validation discard-
counters [interface interface]}
Parameters
binding
Clears the binding table.
Dynamic Host Configuration Protocol (DHCP) 477