Users Guide

host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host address
Parameters
address/mask Enter the host IP address and subnet mask.
Defaults None
Command Modes DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
lease
Specify a lease time for the addresses in a pool.
Syntax
lease {days [hours] [minutes] | infinite}
Parameters
days Enter the number of days of the lease. The range is from 0 to 31.
hours Enter the number of hours of the lease. The range is from 0 to 23.
minutes Enter the number of minutes of the lease. The range is from 0 to 59.
infinite Specify that the lease never expires.
Defaults 24 hours
Command Modes DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
470 Dynamic Host Configuration Protocol (DHCP)