Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

421

422

423

424

425

426

427

428

429

430

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the S6000-ON.

9.4.(0.0) Added support for PBR and VRF.

9.2(1.0) Introduced on the Z9500.

9.2(0.2) Added support for fcoe.

9.1.(0.0) Added support for OpenFlow.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.10.2 Clarified block information for the S4810.

8.3.10.0 Introduced on the S4810.

8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.

8.2.1.0 Introduced on the S-Series.

7.8.1.0 Introduced on the C-Series.

Usage

Information

Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the

system for the new settings to take effect.

The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these blocks

cannot be reallocated. Only 13 number of blocks can be configured by the user .

The ipv6acl allocation must be a factor of 2.

If allocation values are not entered for the CAM regions, the value is 0.

If you enable BMP, to perform a reload on the chassis to upgrade any configuration changes that have

changed the NVRAM content, use the command reload conditional nvram-cfg-change.

cam-acl-egress

Allocate CAM for egress ACLs.

Syntax

cam-acl-egress default | l2acl number ipv4acl number ipv6acl number

Parameters

default

Reset egress CAM ACL entries to default settings.

l2acl

number

Allocate space to each CAM region. The total space allocated must equal 4. The

ipv6acl range must be a factor of 2.

Command Modes CONFIGURATION