Users Guide

ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
ip-address (OPTIONAL) Enter the IP address of the neighbor to view only BGP information
exchanged with that neighbor.
advertised-
routes
(OPTIONAL) Enter the keywords advertised-routes to view only the routes
the neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view information on
dampened routes from the BGP neighbor.
detail (OPTIONAL) Enter the keyword detail to view neighbor-specific internal
information for the IPv4 Unicast address family.
flap-statistics (OPTIONAL) Enter the keywords flap-statistics to view flap statistics on
the neighbor’s routes.
routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s feasible
routes.
received-routes
[ network
[ network-mask ]
(OPTIONAL) Enter the keywords received-routes then either the network
address (in dotted decimal format) or the network mask (in slash prefix format) to
view all information received from neighbors.
NOTE: Configure the neighbor soft-reconfiguration inbound
command prior to viewing all the information received from the neighbors.
denied-routes
[ network
[ network-mask ]
(OPTIONAL) Enter the keywords denied-routes then either the network
address (in dotted decimal format) or the network mask (in slash prefix format)
to view all information on routes denied via neighbor inbound filters.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the
ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Added the detail option. Output now displays the default MED value.
7.2.1.0 Added the received and denied route options.
6.3.10 The output is changed to display the total number of advertised prefixes.
Usage
Information
After a peer reset, the contents of the notification log messages is displayed in hex values for debugging.
400 Border Gateway Protocol