Users Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage
Information
When you enable failover, BGP keeps track of IP or IPv6 ability to reach the peer remote address and the
peer local address. Whenever either address becomes unreachable (for example, no active route exists in
the routing table for the peer IP or IPv6 destination/local address), BGP brings down the session with the
peer.
Related
Commands
● show ip bgp neighbors — display information on the BGP neighbors.
neighbor local-as
To accept external routes from neighbors with a local AS number in the AS number path, configure Internal BGP (IBGP) routers.
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-prepend]
To return to the default value, use the no neighbor {ip-address | peer-group-name}
local-as command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to set the advertisement interval for all routers in
the peer group.
as-number Enter the AS number to reset all neighbors belonging to that AS. The range is from
0 to 65535 (2 byte), from 1 to 4294967295 (4 byte) or from 0.1 to 65535.65535
(dotted format).
no prepend Specifies that local AS values do not prepend to announcements from the neighbor.
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
Border Gateway Protocol 361