Users Guide

vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to install the
IPv6 route in that VRF.
NOTE: It will not be possible to enable VRF mode for IPv6 unicast without
configuring the corresponding IPv4 unicast mode for the same VRF. While
deletion, whenever the IPv4 VRF mode is deleted for the VRF, it will
automatically delete the IPv6 VRF configurations as well.
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for IPv6 VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.5.1.0 Introduced
aggregate-address
To minimize the number of entries in the routing table, summarize a range of prefixes.
Syntax
aggregate-address ip-address mask [advertise-map map-name] [as-set]
[attribute-map map-name] [summary-only] [suppress-map map-name]
Parameters
ip-address mask Enter the IP address and mask of the route to be the aggregate address. Enter the
IP address in dotted decimal format (A.B.C.D) and mask in /prefix format (/x).
advertise-map
map-name
(OPTIONAL) Enter the keywords advertise-map then the name of a configured
route map to set filters for advertising an aggregate route.
as-set
(OPTIONAL) Enter the keyword as-set to generate path attribute information
and include it in the aggregate.
AS_SET includes AS_PATH and community information from the routes included in
the aggregated route.
attribute-map
map-name
(OPTIONAL) Enter the keywords attribute-map then the name of a configured
route map to modify attributes of the aggregate, excluding AS_PATH and
NEXT_HOP attributes.
summary-only (OPTIONAL) Enter the keyword summary-only to advertise only the aggregate
address. Specific routes are not advertised.
suppress-map
map-name
(OPTIONAL) Enter the keywords suppress-map then the name of a configured
route map to identify which more-specific routes in the aggregate are suppressed.
320 Border Gateway Protocol