Users Guide

bit Enter a flag or combination of bits:
● ack: acknowledgement field
● fin: finish (no more data from the user)
● psh: push function
● rst: reset the connection
● syn: synchronize sequence numbers
● urg: urgent field
dscp Enter the keyword dscp to deny a packet based on the DSCP value. The range is
from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
● eq = equal to
● neq = not equal to
● gt = greater than
● lt = less than
● range = inclusive range of ports (you must specify two ports for the port
parameter)
port port Enter the application layer port number. Enter two port numbers if you are using
the range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
● 23 = Telnet
● 20 and 21 = FTP
● 25 = SMTP
● 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
208 Access Control Lists (ACL)