Users Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed specification about entries
allowed per ACL, refer to your line card documentation.
Prior to 7.8.1.0, names are up to 16 characters long.
Example
Dell(conf)# ip access-list extended TESTListEXTEND
Dell(config-ext-nacl)#
Related
Commands
● ip access-list standard — configure a standard IP access list.
● show config — display the current configuration.
permit
To pass IP packets meeting the filter criteria, configure a filter.
Syntax
permit {source mask | any | host ip-address} {destination mask | any | host
ip-address} [count [bytes]] [dscp value] [order] [fragments] [no-drop]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny {source mask | any | host ip-address} {destination mask |
any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the
packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address or
hostname.
destination Enter the IP address of the network or host to which the packets are sent.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes processed by the filter.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
206 Access Control Lists (ACL)