Users Guide

lowest; lower-order numbers have a higher priority) If you did not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the keyword dscp.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for non-contiguous mask and added the monitor option.
Deprecated the keyword established.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more information, see the
Quality of Service section of the Dell Networking OS Configuration Guide.
The monitor option is relevant in the context of flow-based monitoring only. For more information, see
the Port Monitoring section.
The C-Series and S-Series cannot count both packets and bytes; when you enter the count byte options,
only bytes are incremented.
NOTE: When you configure ACL logging and byte counters simultaneously, byte counters may display
an incorrect value. Configure packet counters with logging instead.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (for
example, gt, lt, or range) may require more than one entry. The range of ports is configured in the CAM
based on bit mask boundaries; the space required depends on exactly what ports are included in the
range.
Example
An ACL rule with a TCP port range of 4000–8000 uses eight entries in the CAM.
Rule# Data Mask From To #Covered
202 Access Control Lists (ACL)