Users Guide

order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.10 Expanded to include the optional QoS order priority for the ACL entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. The following applies:
● The seq sequence-number command is applicable only in an ACL group.
● The order option works across ACL groups that are applied on an interface via the QoS policy
framework.
● The order option takes precedence over seq sequence-number.
● If you do not configure sequence-number, the rules with the same order value are ordered
according to their configuration order.
● If you configure sequence-number, the sequence-number is used as a tie breaker for rules with the
same order.
Related
Commands
● deny — configure a filter to drop packets.
● permit — configure a filter to forward packets.
Access Control Lists (ACL) 197