Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
ip access-group
Assign an IP access list (IP ACL) to an interface.
Syntax
ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-
id] [vrf vrf-name]
To delete an IP access-group configuration, use the no ip access-group access-list-name
{in | out} [implicit-permit] [vlan vlan-id] [vrf vrf-name] command.
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action
of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not
match the filters in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The
range is from 1 to 4094 (you can use IDs from 1 to 4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of the VRFs. The range
is from 1 to 63 (you can use IDs from 1 to 63).
NOTE: When you specify a single VRF, use the name of the VRF instead of
the VRF ID number. Use the VRF ID numbers only when you specify a range of
VRFs.
Defaults Not enabled.
Command Modes INTERFACE/VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
188 Access Control Lists (ACL)