Users Guide

mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check operation is started.
Syntax
mep cross-check start-delay number
Parameters
start-delay
number
Enter a start-delay in seconds. The range is from 3 to 100 seconds.
Defaults 3 ccms
Command Modes ETHERNET CFM
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the S-Series.
ping ethernet
Send a loopback message.
Syntax
ping ethernet domain [name l level] ma-name ma-name remote {dest-mep-id |
mac-addr mac-address} source {src-mep-id | port interface}
Parameters
name | level Enter the domain name or level.
ma-name ma-
name
Enter the keyword ma-name and then enter the maintenance association name.
dest-mep-id Enter the MEP ID that is the target of the ping.
mac-addr mac-
address
Enter the keyword mac-addr and then enter the MAC address that is the target
of the ping.
src-mep-id Enter the MEP ID that originates the ping.
port interface Enter the keyword port and then enter the interface that originates the ping.
Defaults None
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
152 802.1ag